Convotherm OGB-10.10 Installation And Maintenance Instructions Manual page 35

Combination oven steamer
Hide thumbs Also See for OGB-10.10:
Table of Contents

Advertisement

i.
Press Smart Key
j.
Step 1 of 4 is Hot Air at 70°C for 10 minutes.
k. Signal Tone sounds and display prompts "CONVOCLEAN." Open the door. (In
ordinary use, the operator sprays CONVOClean oven cleaner into the oven.)
l.
Close the door. Do NOT press the Start / Stop key
2 of 4 automatically.
m. Step 2 of 4 is Steam at 86°F (30°C) for 9 minutes.
n. Signal Tone sounds. Open the door. (In ordinary use, the operator would clean
behind the Suction Plate.)
o. Close the door. Do NOT press the Start / Stop key
3 / 4 automatically.
p. Step 3 of 4 is Steam at 86°F (30°C) for 1 minute. No action is required.
q. Step 4 of 4 is Steam at 212°F (100°C) for 10 minutes.
r.
Signal Tone sounds. Turn OFF the unit with the ON / OFF key
s. (In ordinary use the operator would carefully open the door and rinse the Combi with
the Hand Shower)
t.
Leave door open slightly
4. For CONVOClean System equipped Combis:
a. The oven chamber must be cold before starting this process.
b. Before starting, remove large pieces food or cooking residue from the oven chamber.
This will help prevent the drain from becoming blocked.
c. Check the level of CONVOTHERM by Cleveland oven cleaner and nozzle rinsing
fluid. The containers must be full and the suction pipes must be located in the fluid.
d. Press Smart Key
e. Use the Selector Dial
f.
Confirm by pressing Smart Key
g. Select the level of cleaning
1) light soiling
2) medium soiling
3) heavy soiling
4) heavy soiling with Shine+
h. PRESS the Temperature key
i.
Press Smart Key
j.
The display reads "Food inside oven?" If the oven is empty then answer "No."
k. Confirm by pressing Smart Key
l.
The display reads "Start auto-cleaning?" Answer "Yes" or "No" as desired.
m. Confirm by pressing Smart Key
n. The program will start the CONVOClean system automatically.
1) Check the supply of CONVOClean and CONVOCare.
2) Make sure the connections are correct.
3) Use only CONVOClean, CONVOClean forte, and CONVOCare for cleaning.
4) Use only Cleveland Range Dissolve for descaling the steam generator.
to start the cleaning cycle.
. Various options will appear in the display.
D
to select "CONVOClean system"
6019002_00
.
and select cleaning level with the Selector Dial
.
.
.
29
. The cleaning cycle starts step
. The cleaning cycle starts step
.
.
D
.
6019002_00

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents