Related Manuals for Audio Technica ATW-0327
Summary of Contents for Audio Technica ATW-0327
- Page 1 300 Series Professional VHF Wireless Systems ATW-0327 UniPak ™ Transmitter System ATW-0328 Handheld Dynamic Microphone System Installation and Operation...
-
Page 2: Receiver Installation
Installation and Operation Receiver Installation Location This device complies with part 15 of the FCC Rules. Operation is subject to the condition that For best operation the receiver should be at least 3' above the ground and at least 3' away from a this device does not cause harmful interference. -
Page 3: Transmitter Setup
Lift the white “battery keeper” arm until it sticks straight out from the mic body (no higher). Then Transmitter Setup carefully insert a fresh 9-volt alkaline battery, observing correct polarity as marked inside the battery compartment. The transmitter housing is designed to prevent incorrect installation of the battery. Battery Selection Do not force the battery in. -
Page 4: System Operation
• Guitar/Instrument: Adjusting input level System Operation While playing at typically-loud levels, carefully turn the GT control clockwise while watching the receiver’s AF Peak indicator. Increase the GT control setting until the AF Peak indicator lights. Check the frequency of the system against the chart on page 9 to ensure you have a proper This indicates that maximum transmitter modulation without significant distortion has been frequency for your area. - Page 5 Wireless Operating Frequencies System Operating Frequencies Frequency Selection Application Freq. Code Freq. (MHz) Each transmitter/receiver system operates on a single factory-aligned, crystal-controlled frequency. • Traveling frequencies: 169.505 Available frequencies are shown in the chart on the following page. (Normally work anywhere in the U.S.A. and 170.245 Operating frequency is specified by a two- or three-character code, such as “T2”...
-
Page 6: Specifications
Optional System Accessories Specifications Overall System Wireless Essentials Microphones and Cables ™ Operating Frequency VHF high band, 169 MHz to 207 MHz All Wireless Essentials accessories are terminated for use with ATW-T27 and other Frequency Stability ± 0.005% UniPak ™ transmitters. - Page 7 Notice to individuals with implanted cardiac pacemakers or AICD devices: Any source of RF (radio frequency) energy may interfere with normal functioning of the implanted device. All wireless microphones have low-power transmitters (less than 0.05 watts output) which are unlikely to cause difficulty, especially if they are at least a few inches away.