AT&T Quickfire User Manual page 156

ADAPTER/CHARGER
CHARGER
The charger designed by Personal Communications Devices for this unit
requires the use of a standard 120 v AC power source for its operation.
• Never attempt to disassemble or repair a charger.
• Never use a charger if it has a damaged or worn power cord or plug.
Always contact a Personal Communications Devices authorized service
center, if repair or replacement is required.
• Never alter the AC cord or plug on your charger. If the plug will not fit
into the available outlet, have a proper outlet installed by a qualified
electrician.
• Never allow any liquids or water to spill on the charger when it is
connected to an AC power source. Always use the authorized Personal
Communications Devices charger to avoid any risk of bodily injury or
damage to your cellular phone or battery.
• Never attempt to connect or disconnect the charger with wet hands.
Always unplug the charger from the power source before attempting
any cleaning. Always use a soft cloth dampened with water to clean
the equipment, after it has been unplugged.
Handling the cord on this product or cords associated with accessories
sold with this product, will expose you to lead, a chemical known to the
State of California to cause birth defects or other reproductive harm.
Wash hands after handling. Always disconnect the charger from the
power source when it is not in use.
SAFETY
155 155