Battery Charging - AT&T Quickfire User Manual

BATTERY CHARGING

POWER CONNECTION
1.
Plug the AC Charger into a standard outlet.
2.
To access the charging port located on the upper side of your
Quickfire, as seen on page 7, open the flap and plug the other end of
the AC Charger into the charging port. The battery must be installed
onto the phone to work properly.
3.
The clearly marked, embossed arrow on the AC Charger adapter
should always be face-up on the same side as the display screen when
it is inserted into the Quickfire phone. See the diagram below for
proper positioning and insertion of the AC Charger adapter into the
phone. You should never force the AC Charger adapter into the phone.
• When you charge the battery with the phone powered off, you will see a
Note
charging status screen. You cannot operate the phone until it is powered on.
• The battery is not charged at the time of purchase.
• Fully charge the battery before use.
• It is more efficient to charge the battery with the handset powered off.
• The battery must be connected to the phone in order to charge it.
• Battery operating time gradually decreases over time.
• If the battery fails to perform normally, you may need to replace the battery.
Please refer to the Manufacturer's Warranty on page 160 for further
information.

Embossed
arrow should
always face up
BATTERY USAGE

13 13