RCA RCRPS04GR Owner's Manual page 5

NOTES: Throughout the programming of each
key, be sure to keep the remote pointed at
the IR sensor of the device you are currently
programming the remote to control.
Test the remote with the device to make sure the
device key is programmed with the correct code
for maximum functionality. If some features don't
work, try a different code. See the "Testing the
Code for Maximum Functionality" section below
for more information.
During the Brand Code Search, the remote
ignores keypresses that aren't part of the search.
The search times out after two minutes (the
POWER key blinks four times and the last
programmed code under that device key is
retained).
The POWER key blinks four times when the
remote has gone through all the codes. The
remote exits the Brand Code Search. If your
device hasn't turned off yet, try a different search
method.
Testing the Code for Maximum Functionality
1. Try a variety of the device's functions with the
remote. If some device features don't work, go to
the next step to try a different code.
2. Repeat the Brand Code Search from the
beginning. When the device turns off for the fi rst
time, don't press the OK/ENTER key, which would
store the same code. Instead, with the unit now
off, continue to press the GUIDE key repeatedly
until the unit turns back on.
3. Once the unit turns back on, you have found
another code that operates the device. Press the
OK/ENTER key.
4. Test the key's functionality again by attempting
to control a variety of the device's functions.
If the code that has been stored controls the
majority of the device's functions, programming
is complete. If the code stored does not give
maximum functionality, try another code.
5