RCA RCRPS04GR Owner's Manual page 4

1.
Manually turn on the device
you want to control.
2.
Find your device's brand in
the Brand Code list section
of the accompanying code
list. Circle the number for
your brand and keep the list
handy.
3.
Press and hold the device key you want to
program (the POWER key illuminates). While
you're holding down the device key, use your
other hand to press and hold the remote's
POWER key at the same time (the POWER key
turns off).
4.
Wait until the POWER key comes on and stays
on. Then release both keys.
5.
Look at the numbers you
circled for your device's
brand code. Press those
numbers on the remote
keypad.
Note: For single-digit brand
codes, press the 0 key fi rst
(for example, 0-5 for 5).
6.
Point the remote directly at
the front panel of the device
you want to control. Press
GUIDE on the remote and
wait 2 seconds. The remote
is sending a single code for
your device's brand.
Did your device turn off?
YES: Press the remote's POWER key to turn
your device back on. Then test all of the
following remote keys that your device uses:
VOL+, CH+, 0 digit, PLAY, and STOP. If these
keys work, press OK/ENTER. If they don't,
repeat this step until your device turns off
again.
NO: Press GUIDE again. The remote sends the
next code for your brand.
Keep pressing GUIDE every 2 seconds until
your device turns off. When it does, press OK/
ENTER.
4