Kyocera FS-2100DN Operation Manual page 133

AppleTalk:
1 Off
2 *On ********************-
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the standard by the IETF for authentication and encryption in
the third network layer (IP layer).
It can be used with both IPv4 and IPv6.
Note IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP addresses.
IPSec:
1 *Off
********************-
2
On
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used. The default setting is Auto.
Note LAN Interface is only displayed when the optional network interface kit (IB-50) is installed.
LAN Interface:
1 *Auto
********************-
2
10Base-Half
3
10Base-Full
2
Press [OK]. The AppleTalk screen appears.
a b
3
Press  or  to select whether AppleTalk is enabled.
4
Press [OK]. The AppleTalk setting is set and the Basic menu
reappears.
1
In the Basic menu, press  or  to select IPSec.
2
Press [OK]. The IPSec screen appears.
a b
3
Press  or  to select whether IPSec is enabled.
4
Press [OK]. The IPSec setting is set and the Basic menu reappears.
1
In the Basic menu, press  or  to select LAN Interface.
2
Press [OK]. The LAN Interface screen appears.
a b
The available LAN Interface are as follows:
Auto
10Base-Half
10Base-Full
100Base-Half
100Base-Full
1000Base-T
3
Press  or  to select the desired LAN Interface.
4
Press [OK]. The LAN Interface is set and the Basic menu
reappears.
4-71
Operation Panel