What Happens If An Incorrect Cd Is Inserted; How To Turn The Security Indicator On/Off; How To Read The Electronic Serial Number - Eclipse CD2000 Owner's Manual

Various Settings
What happens if an incorrect CD is
inserted?
After the 5th incorrect attempt, the
1
display reads
seconds.
After the [HELP] message appears for
five seconds,
appear.
Press the [DISP FUNC] button,
2
then the button [6], and hold them
for five seconds.
After the [SEC] message appears for
two seconds, rolling code (six digit) will
appear.
3
Press the [DISP FUNC] button.
[DISC] flashes on the display.
You will have five more attempts to
insert correct disc.
4
Insert the Key CD into the slot.
If the correct CD is inserted, an [OK]
message will appear for two seconds
and the CD will be ejected.
ATTENTION
• If an incorrect CD is inserted, an [ERR_ ]
("ERR" and error number) message will
appear for two seconds, after which the CD
will be ejected.
• This process cancels the protection for ESN
equipment.
● Note ●
If after 5 tries the correct Key CD is not
inserted, the display will read [CALL];
the equipment must be returned to
Eclipse to be reset. In this case,
please contact your Eclipse dealer for
assistance.
28
[HELP] for five
serial number will
Your Key CD can be easily forgotten.
Write the album name in a reminder
note (See page 44).
How to turn the security
indicator on/off
Once ESN security is activated, the indicator
flashes whenever the vehicle's ignition switch is
turned off, warning potential thieves that the
equipment is protected. However, if do not want
this visible deterrent, it may be turned off.
With the equipment in standby,
1
press the [DISP FUNC] button, then
the button [2] and hold both for
more than one second.
[IND. FLASH] or [IND.-----] appears
2
on the display.
[IND. FLASH] means the security
indicator will flash when the vehicle's
ignition switch is off, and [IND.-----]
means it will not. Repeat the above
steps to reactivate the flash mode.
How to read the Electronic
Serial Number
Check that the equipment is in
1
standby.
Press and hold the [DISP FUNC]
2
button, then the button [4], and
hold both for more than one
second.
[ESN] appears on the display, followed
by an eight-digit number; this number
is your electronic serial number (ESN).
You may use this number to identify
your Eclipse CD2000 in the event of
theft recovery.