HP 2730p - EliteBook - Core 2 Duo 1.86 GHz Maintenance And Service Manual page 58

Removal and replacement procedures
3. Turn the computer right-side up, with the front toward you.
4. Open the computer as far as possible.
5. Release the ZIF connector
board cable from the system board.
6. Release the ZIF connector
from the system board.
7. Remove the two Phillips PM2.0×5.0 screws
8. Lift the front edge of the top cover
9. Remove the top cover by pulling it away from the computer
Reverse this procedure to install the top cover.
4–22
to which the TouchPad board cable is connected and disconnect the TouchPad
to which the LED board cable is connected and disconnect the LED board cable
that secure the top cover to the computer.
until it rests at an angle.
at an angle.
Maintenance and Service Guide