HP 2730p - EliteBook - Core 2 Duo 1.86 GHz Maintenance And Service Manual page 47

Removal and replacement procedures
3. Remove the two Phillips PM2.0×3.0 screws that secure the hard drive bracket to the computer.
4. Remove the hard drive bracket .
5. Disconnect the hard drive connector cable from the system board.
6. Release the hard drive by sliding it to the right, and then lifting the rear edge until the hard drive rests at
an angle.
7. Lift the hard drive straight up to remove it from the hard drive compartment.
Reverse this procedure to reassemble and install the hard drive.
Maintenance and Service Guide 4–1 1