Removal and replacement procedures
Remove the WLAN module:
1. Disconnect the WLAN antenna cables
✎
The black WLAN antenna cable is connected to the WLAN module "Main" terminal. The white WLAN antenna
cable is connected to the WLAN module "Aux" terminal.
2. Remove the two Phillips PM2.5×4.0 screws
module opposite the slot rises away from the computer.)
3. Remove the WLAN module
✎
WLAN modules are designed with a notch
Reverse this procedure to install the WLAN module.
4–14
from the terminals on the WLAN module.
that secure the WLAN module to the computer. (The edge of the
by pulling the module away from the slot at an angle.
to prevent incorrect insertion into the WLAN module slot.
Maintenance and Service Guide