Assembling The Inner Rails - HP A7340A - Surestore FC 1Gb/2Gb Switch 16B Installation Manual

5. Assemble the two inner rails (one on each side) to the switch using ten
The inner rails work for all three SAN switches—SAN Switch 2/32, SAN Switch
2/16, and SAN Switch 2/8. The mounting holes in the inner rails are marked with
32, 16, and 8. Use the appropriately labeled mounting holes when installing the
inner rails on a switch. For example, to install the inner rails on the SAN Switch
2/16, use the mounting holes labeled 16.
Note:
assembling the inner rails. Each switch requires a different number of these
screws. For example,
Switch 2/16 with five screws. Attaching both inner rails requires ten screws.
Figure 19: Assembling the inner rails
SAN Switch 2/16 Version 3.1.x Installation Guide
#8-32 x 3/16-inch Phillips pan-head screws with captive star lock washers as
shown in Figure 19.
Caution: Do not use any other screws other than the ones provided. Use of
any longer lengths can cause damage to internal components
The rail kit provides a total of fourteen #8-32 x 3/16-inch screws for
Figure 19 shows the an inner rail being attached to the SAN
Installing the SAN Switch 2/16
53