Changing The Admin Password And User Id - HP A7340A - Surestore FC 1Gb/2Gb Switch 16B Installation Manual

Managing the SAN Switch 2/16
Note:
enable connection through telnet.
2. At the login prompt, enter the user ID you are logging in as. For example:
3. Enter the password for the user:
4. If the login was successful, a prompt displays showing the switch name and

Changing the Admin Password and User ID

Use these steps to change the Admin user ID and password.
Note:
to change the admin user ID and system password.
1. Log into the switch as the admin user.
2. At the command line, enter the following command:
3. At the New Username prompt, enter a new name for the admin user. You
4. At the Old Password prompt, enter the old password.
5. At the New Password prompt, enter the new password. The new password
80
The switch must be connected to your IP network through the RS-232 port to
login: admin
The password prompt is displayed if the user exists.
password: xxxxxx
The default password is password.
user ID you are logged in as. For example:
switch55>admin:
For security reasons, the first time you log into the Fabric OS you are requested
Password admin
An interactive session is opened and you are prompted for configuration
values.
can change the name of the admin user without changing the password. Press
Enter to leave the name as is.
must be from 8 to 40 characters in length.
SAN Switch 2/16 Version 3.1.x Installation Guide