Windows Ce-Related Problems - Pentax 203125 - PocketJet II B/W Direct Thermal Printer User Manual

The print head has overheated. Turn the printer off and allow it to cool
before continuing to print. The printer may overheat if you use it over
an extended period at a very high print density.

Windows CE-related Problems

I get an error message on my WinCE HPC when I try to
print
Make sure the correct printer and port are selected. Make sure the
printer cable is connected or the IrDa ports are aligned (if using
infrared). Make sure the WinCE HPC is not connected to a PC. Try
resetting the WinCE HPC according to the manufacturer's directions.
I must always select "landscape" mode when trying to
print
This is required by Windows CE version 2.0.
There seems to be no way to print from my application
Your application may not support printing under Windows CE. Call
the application vendor and request an update.
The printing is VERY slow
Some WinCE HPCs print more quickly with infrared than cable. Try
both methods to determine the best for you.
I have to wait for a period of time after the last line of a
print job for the paper to eject.
This is normal. Each WinCE HPC has a different wait time after a print
job completes before it sends an eject signal to the printer.
I can only print one copy of a document when using
infrared, then my WinCE HPC won't print any further.
This problem occurs when using certain HPCs (HP 620LX and perhaps
others). Save and close all open documents (which will close the
application), then reopen and print the desired document. You can also
try pressing the CONTROL+period (.) to toggle between documents
(without closing the application) and try printing again.
Page 48