Cleaning The Printer's Exterior - Pentax 203125 - PocketJet II B/W Direct Thermal Printer User Manual

5. The roller may be stopped by pressing the main switch briefly once
more. Otherwise, the roller movement will stop automatically after
about 60 seconds. In either case, the printer remains in Cleaning
Mode until the printer is turned OFF, the Cleaning Mode is disabled
by resetting the DIP switch, and the printer is turned back ON.
CAUTION: Do not attempt to clean the platen roller with any
material other than the cleaning cloth.
The cleaning cloth is for head cleaning and platen
roller cleaning only. Do not use it to clean any other
part of the printer.
6. Reset the Cleaning Mode to OFF by turning the printer off, resetting
DIP switch 4, and turning the printer back on.
NOTE: Don't throw the cleaning cloth away after you clean the
platen roller. It should last for the life of the printer. Keep
the cleaning cloth with your printer supplies and use it
whenever you need to clean the platen roller or the print
head.

Cleaning the Printer's Exterior

Should the outside of the printer become dirty, clean it using a soft
cloth moistened with water. If necessary, add a very small amount of a
mild soap such as a liquid dishwashing detergent.
CAUTION: Avoid saturating the cloth. Do not allow water to get
inside the printer.
Avoid the use of benzene, alcohol, paint thinner, or
cleaners that are abrasive, alkaline, or acidic. Such
cleaners may damage the printer's case.
Page 38