Configuring Static Routes - NETGEAR FVS318G-100NAS Reference Manual

ProSafe Gigabit 8 Port VPN Firewall FVS318G Reference Manual
If you will use a Lightweight Directory Access Protocol (LDAP) authentication server for
network-validated domain-based authentication, select Enable LDAP Information to
enable the DHCP server to provide LDAP server information. Enter the following
settings:
– LDAP Server. Specifies the name or the IP address of the device that hosts the LDAP
server.
– Search Base. Specifies the distinguished name (dn) at which to start the search,
specified as a sequence of relative distinguished names (rdn), connected with commas
and without any blank spaces. For most users, the search base is a variation of the
domain name. For example, if your domain is yourcompany.com, your search base dn
might be as follows: dc=yourcompany,dc=com.
– port. Specifies the port number that the LDAP server is using. Leave this field blank
for the default port.
• DHCP Relay. Select this radio button to use the VPN firewall as a DHCP relay agent for a
DHCP server somewhere else on your network. In the Relay Gateway field, enter the IP
address of the DHCP server for which the VPN firewall serves as a relay.
5. In the DNS Proxy section, select the Enable DNS Proxy checkbox to enable the DHCP server
to provide the VPN firewall's LAN IP address for DNS address name resolution. If this
checkbox is deselected, the DHCP server will provide the ISP's DNS server IP addresses, but
the VPN firewall will still service DNS requests that are sent to its LAN IP address.
6. Click Apply to save your settings or click Reset to discard any changes and revert to the
previous configuration.
When you enable the DMZ server, the DMZ LED next to LAN port 8 (see
and Rear Panels" on page
To define the DMZ WAN Rules and LAN DMZ Rules, see
page 4-12 and "Configuring LAN DMZ Rules" on page

Configuring Static Routes

Static routes provide additional routing information to your VPN firewall. Under normal
circumstances, the VPN firewall has adequate routing information after it has been configured for
Internet access, and you do not need to configure additional static routes. You should configure
static routes only for unusual cases such as multiple firewalls or multiple IP subnets located on
your network.
3-14
1-6) will light up indicating that the DMZ port has been enabled.
v1.1, August 2010
"VPN Firewall Front
"Configuring DMZ WAN Rules" on
4-13, respectively.
LAN Configuration