NETGEAR FVS318G-100NAS Reference Manual page 50

ProSafe Gigabit 8 Port VPN Firewall FVS318G Reference Manual
The DMZ Setup screen allows you to set up the DMZ port. It permits you to enable or disable the
hardware DMZ port (LAN port 8, see
configure an IP address and Mask for the DMZ port.
To enable and configure the DMZ port:
1. From the main menu, select Network Configuration and then select DMZ Setup from the
submenu. The DMZ Setup screen displays.
2. In the DMZ Port Setup section, under Do you want to enable DMZ Port?, select the Yes
radio box.
3. Enter an IP address and the subnet mask for the DMZ port. Make sure that the DMZ port IP
address and LAN Port IP address are in different subnets (for example, an address outside the
LAN Address pool, such as 192.168.1.101).
Figure 3-5
3-12
"VPN Firewall Front and Rear Panels" on page
v1.1, August 2010
1-6) and
LAN Configuration