Managing Groups And Hosts (Lan Groups) - NETGEAR FVS318G-100NAS Reference Manual

Gigabit 8 port vpn firewall
Table of Contents

Advertisement

If you will use a Lightweight Directory Access Protocol (LDAP) authentication server for
network-validated domain-based authentication, select Enable LDAP Information to enable
the DHCP server to provide LDAP server information. Enter the following settings:
LDAP Server. Specifies the name or the IP address of the device that hosts the LDAP
server.
Search Base. Specifies the distinguished name (dn) at which to start the search, specified
as a sequence of relative distinguished names (rdn), connected with commas and without
any blank spaces. For most users, the search base is a variation of the domain name. For
example, if your domain is yourcompany.com, your search base dn might be as follows:
dc=yourcompany,dc=com.
port. Specifies the port number that the LDAP server is using. Leave this field blank for
the default port.
4. In the Advanced Settings section, configure the following settings:
Enable DNS Proxy. If the DNS proxy is enabled (which is the default setting), the DHCP
server will provide the VPN firewall's LAN IP address as the DNS server for address
name resolution. If this box is unchecked, the DHCP server will provide the ISP's DNS
server IP addresses. The VPN firewall will still service DNS requests sent to its LAN IP
address unless you disable DNS Proxy in the VPN firewall settings (see
on page
4-20).
Enable ARP Broadcast. If ARP broadcast is enabled (which is the default setting), the
Address Resolution Protocol (ARP) is broadcasted on the LAN so that IP addresses can be
mapped to physical addresses (that is, MAC addresses).
5. Click Apply to save your settings or click Reset to discard any changes and revert to the
previous configuration.
Note: Once you have completed the LAN IP setup, all outbound traffic is allowed
and all inbound traffic is discarded. To change these traffic rules, refer to
Chapter 4, "Firewall Protection and Content

Managing Groups and Hosts (LAN Groups)

The Known PCs and Devices table on the Groups and Hosts screen contains a list of all known
PCs and network devices, as well as hosts, that are assigned dynamic IP addresses by this VPN
firewall. Collectively, these entries make up the Network Database.
LAN Configuration
ProSafe Gigabit 8 Port VPN Firewall FVS318G Reference Manual
v1.1, August 2010
"Attack Checks"
Filtering."
3-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Prosafe fvs318g

Table of Contents