Add And Register A Headset - VTech IS6100 User Manual

Getting started

Add and register a headset

Each newly purchased headset (IS6100) must be registered to a VTech DECT 6.0
cordless telephone system before use. Visit www.vtechphones.com for a list of
compatible telephones.
The telephone base recognizes and counts a headset the same as a handset. You
can place the headset charger anywhere you have an available power outlet.
Refer to your telephone user's manual for a maximum number of headsets that you
can register to the telephone base. If you already have the maximum number of
handsets/headsets registered, you need to follow the deregistration information in
your telephone user's manual before adding a new headset.
To register a headset:
1. Place the non-registered headset in the headset charger and allow it to charge for
at least 15 minutes before beginning registration. Remove the headset from the
headset charger. The
and blue.
2. On the telephone base of the cordless telephone, press and hold
/FIND HANDSET for about four seconds until the red IN USE light turns on. Then
release the button.
3. Immediately place the headset in the headset charger. It takes about 60 seconds
to complete the registration process. The red IN USE light on the telephone base
turns off. The
charged, or turns blue if it is registered and fully charged.
If the registration process is successful, you hear a dial tone when you press
the headset. If the registration fails, you hear "Not registered" when you press
the headset. The
blue. To reset the headset, remove it from the headset charger and then place it back
into its charger. Try the registration process again.
• You cannot register a headset if any other system handset or headset is in use. You
can only register one headset to the telephone base at a time.
• The headset must be deregistered before registering it to another telephone system.
light on the headset flashes slowly and alternately in red
light on the headset turns red when it is registered but not fully
light on the headset flashes slowly and alternately in red and
4
on
on