HP 8100 - Elite Convertible Minitower PC Maintenance And Service Manual page 128

6. Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive
toward the front of the computer until it locks into place.
Figure 7-32
7. Rotate the drive cage to its upright position.
Figure 7-33
8. Connect the SATA data cable to the white system board connector labeled SATA1.
9. Route the data cable through the cable guides.
CAUTION:
drive cage when raising or lowering it. One is located on the bottom side of the drive cage. The
other is located on the chassis frame under the drive cage. Ensure that the data cable is routed
through these guides before connecting it to the optical drive.
118 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
Installing the Optical Drive
Rotating the Drive Cage Up
There are two cable guides that keep the data cable from being pinched by the