HP 8100 - Elite Convertible Minitower PC Maintenance And Service Manual page 120

8. To install a new expansion card, hold the card just above the expansion socket on the system
board then move the card toward the rear of the chassis (1) so that the bracket on the card is
aligned with the open slot on the rear of the chassis. Press the card straight down into the
expansion socket on the system board (2).
Figure 7-22
NOTE:
connector seats properly in the expansion card slot.
9. Rotate the slot cover retention latch back in place to secure the expansion card.
Figure 7-23
10. Connect external cables to the installed card, if needed. Connect internal cables to the system
board, if needed.
11. Replace the access panel.
12. If the computer was on a stand, replace the stand.
110 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
Installing an Expansion Card
When installing an expansion card, press firmly on the card so that the whole
Closing the Expansion Slot Retainer