Ricoh C222DN - Aficio SP Color Laser Printer Software Manual page 19

L
When a message appears informing you that the installation was success-
fully completed, click [Finish].
Note
❒ In a Windows Vista environment, depending on security settings, the [User
Account Control] dialog box might appear after you insert the CD-ROM. If
this is the case, click [Allow].
❒ If the printer driver is already installed, plug and play is enabled and the
printer connected to the USB port appears automatically in the [Printers]
window.
❒ When USB is first used, plug and play starts. Then the [New Hardware
Found], [Device Driver Wizard], or [Add New Hardware Wizard] dialog box ap-
pears, depending on the operating system.
❒ To disable Auto Run, press the left the {Shift} key when inserting the CD-
ROM into the drive and keep it pressed until the computer finishes reading
from the CD-ROM.
❒ The number after "USB" varies depending on the number of printers con-
nected.
❒ A message appears if the printer connection fails. Check the USB cable is
connected and the printer's main power switch is turned to on, and then
click [Retry].
❒ To stop USB auto detection, click [Stop Auto-detecting].
❒ The USB port is available only for the printer driver that is installed first.
To install additional drivers for this printer, install them using other ports
(such as LPT1). Then, after the installation, change the port settings to the
specified USB port.
Installing the Printer Driver Using USB
1
11