Dell Inspiron 2650 User Manual page 138

EMI Shield, Video Card, and Palm Rest: Dell Inspiron 2600 and 2650
Back to Contents Page
EMI Shield, Video Card, and Palm Rest
Dell™ Inspiron™ 2600 and 2650
EMI Shield
Video Card
Palm Rest
EMI Shield
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and
remove any installed battery.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching
an unpainted metal surface on the computer.
NOTICE: Read
procedure.
1. Remove the keyboard.
2. Remove the two M2.5 x 5-mm screws that secure the display-feed flex cable to the
system board.
NOTICE: When reconnecting the display-feed flex cable connector to the system board,
push down on the top left and right ends of the connector. Pressing on the center of the
connector may damage resistors and compromise EMI protection in the computer.
3. Pull up on the pull tab that is attached to the display-feed flex cable connector to remove
the connector from the system board.
4. Remove the three M2.5 x 12-mm screws that secure the EMI shield to the bottom case,
and pull the EMI shield out of the bottom case.
file:///F|/Service%20Manuals/Dell/Inspiron/2600-50/palmrest.htm (1 of 11) [2/28/2004 6:52:45 AM]
"Preparing to Work Inside the Computer" before performing the following