Installing And Securing The Shelf; Attaching Sliding Shelf To Rear Mounting Bracket - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Sliding Shelf Installation for HAFM Server

Installing and Securing the Shelf

Use the following procedure to complete the shelf installation:
1. Insert the shelf into the rack so that both rail rear slots slide over the loose screws
on inside face of each rear mounting bracket as shown in
2. Make sure that the sliding shelf and rails are horizontal at the rack front.
3. Push each of the rail front tabs into the corresponding holes on the rack columns.
4. At the back of the rack, tighten the screws that attach the sliding shelf rails to the
rear mounting brackets.
Figure 10–4: Attaching sliding shelf to rear mounting bracket
10–4
Figure 10–4.
HAFM server installation guide