Sliding Shelf Installation For Hafm Server; Installing The Rear Mounting Brackets - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

This chapter contains information on how to install the optional sliding shelf for the
HAFM server in an appropriate HP, or comparable, 19-inch Electronic Industries
Association (EIA) rack, as follows:
• HP 9000, 10000 and 11000 series rack
• HP rack system/e or 19-inch EIA rack
NOTE: The installation of the HAFM server sliding shelf is not supported in the m-series
cabinet.

Installing the Rear Mounting Brackets

Use the following procedure to install the rear mounting brackets for the HAFM
server shelf:
1. Select a U slot above the switch.
NOTE: HP recommends that you select the U slot immediately above the switch. However,
other U slots above the switch may also be used.
2. On each rack rear column, locate the hole that is 2 holes up from the EIA number
of the selected U slot.
3. Line up this hole with the threaded hole on the rear mounting bracket's side.
4. Using a screw attach the bracket to the rack as shown in
NOTE: Figure 10–1
11000 series rack (square holes). If installing the bracket in a system/e rack (round holes), the
square alignment washer is not required.
HAFM server installation guide
Sliding Shelf Installation for
depicts the rear mounting bracket installation in an HP 9000, 10000 or
HAFM Server
Figure 10–1.
10
10–1