Configuring Ssl; Osms Configuration Page - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Figure 3-11

Configuring SSL

resides on an open-systems interconnection (OSI) device. This device
is attached to a director or switch port. The device communicates
with the switch or director through Fibre Channel common transport
(FC-CT) protocol.
Use the following procedure to configure OSMS and host control:
1. Select Configure > OSMS on the navigation panel. The OSMS
configuration page

OSMS Configuration Page

2. Select the Enable button to enable OSMS management of the
product through an open-systems interconnection (OSI) device.
Select the Disable button to disable OSMS management of the
product.
3. Enable host control on the product by selecting the Enable Host
Control check box. (To enable host control, OSMS management
must be enabled.) Disable host control by clearing the check box.
Select the OK button to activate your change.
The SSL configuration page provides you with the ability to
configure the Secure Sockets Layer (SSL). SSL is a commonly-used
protocol for managing the security of a message transmission on the
Internet. SSL uses a public-and-private key encryption system, which
includes the use of a digital certificate. The certificate enables a server
to be authenticated.
The SSL configuration page is divided into the following sections:
• Enable/Disable section—Provides the ability to enable and
disable Web SSL and Software SSL.
(Figure 3-11) displays.
Configuring the Product

Configuring SSL

3
3-21