Paper Feed Pick Arm Assembly With Motor And Paper Path Sensor Removal - Lexmark J110 Service Manual

4085-001
Paper Feed Pick Arm Assembly with Motor and Paper
Path Sensor Removal
1. Remove all covers.
2. Remove power supply. Refer to
page 4-19.
3. Remove the frame from the base. Refer to
Removal" on page
4. Remove the two lower screws on the base of the RIP shield.
5. Disconnect the integrated tray connector (J6) from the engine
board and disconnect the paper path sensor.
6. Remove the E-clip {A} from the pick assembly shaft.
7. Remove the screw {B} from the paper feed frame assembly.
8. Slide the shaft to the left and remove the pick arm assembly.
9. Disconnect the wire from the paper path sensor and snap the
sensor out to remove. When reinstalling, note the routing of the
wires and position of spring.
"Power Supply Removal" on
4-27.
"Frame From Base
Repair Information
4-31