Cam Engine Motor With Gear Removal - Lexmark J110 Service Manual

4085-001

Cam Engine Motor with Gear Removal

1. Remove the rear cover. Refer to
page 4-3.
2. Remove the exit tray cover. Refer to
page 4-5.
3. Remove the left cover. Refer to
page 4-7.
4. Disconnect the cam engine motor connector (J8) from the
engine board.
5. Remove the two screws {A} from the motor.
6. Remove the motor through the front of the printer. Note the
routing of the wires.
"Rear Cover Removal" on
"Exit Tray Removal" on
"Left Cover Removal" on
Repair Information
4-29