4085-001
Index Card Assembly Removal
1. Remove the rear cover. Refer to
page
4-3.
2. Remove the exit tray cover. Refer to
page
4-5.
3. Remove the left cover. Refer to
page
4-7.
4. Unplug the index board connector.
5. Remove the three screws {A} from the index board.
6. Remove the index card.
Note: The index card and the encoder disk feed roller must be
replaced as a matching set. See
Assembly Removal" on page
4-22
Service Manual
"Rear Cover Removal" on
"Exit Tray Removal" on
"Left Cover Removal" on
"Encoder Disk Feed Roller
4-34.