Pump Housing/Maintenance Station/Ink Waste Tank/Transport Carrier Motor Removal - Lexmark J110 Service Manual

4085-001
Pump Housing/Maintenance Station/Ink Waste Tank/
Transport Carrier Motor Removal
1. Remove all covers.
2. Remove the power supply. Refer to
page 4-19.
3. Slide the ink waste tank out the rear of the printer. Note the
routing of the hose into tank.
4. Remove the carrier belt. Refer to
Removal" on page
5. Disconnect transport carrier motor cable from engine board.
6. Remove three screws {A} from the transport carrier motor
bracket.
7. Remove the motor and bracket.
8. Loosen the screw on the maintenance bracket and depress the
spring, then retighten the screw.
9. Remove the spring from the rear of the maintenance station.
10.Remove the screw {B} from the right side of the frame that
secures the pump housing maintenance station assembly.
11.Push in the guide post {C} and move the pump housing
maintenance station assembly forward and down to disconnect
it from the shaft.
12. Slide the assembly out the rear of the printer and remove.
4-20
Service Manual
"Engine Board /Cover
4-14.
"Power Supply Removal" on