Paper Feed Frame And Motor/Cam Shaft Assembly Removal - Lexmark J110 Service Manual

4085-001
Paper Feed Frame and Motor/Cam Shaft Assembly
Removal
1. Remove all covers.
2. Remove the carrier and belt. Refer to
Removal" on page
3. Remove pump housing, maintenance station, tank and
transport carrier motor. Refer to
Station/Ink Waste Tank/Transport Carrier Motor Removal" on
page 4-20.
4. Remove the star wheel shaft. See
Removal" on page
5. Remove paper feed platen. Refer to
Assembly Removal" on page
6. Remove encoder disk and feed roller assembly. Refer to
"Encoder Disk Feed Roller Assembly Removal" on page
7. Remove frame from base. Refer to
Removal" on page
8. Disconnect all cable connectors from the engine board.
9. Remove the two E-clips {A} on the backup roller assembly shaft.
10. Remove the two upper frame support screws {B}.
11. Move the paper feed frame with motor to the right and remove.
12. Pull the cam shaft assembly to the right and remove the gear.
13. Remove the cam shaft assembly. Before removing the paper
feed frame and motor, note the position of the bat wings on the
cam shaft.
4-40
Service Manual
4-14.
"Pump Housing/Maintenance
4-36.
4-38.
4-27.
"Engine Board /Cover
"Star Wheel Shaft Assembly
"Paper Feed Platen
"Frame From Base
4-34.