Response To Diagnostic Command - Fujitsu MHN2100AT - Mobile 10 GB Hard Drive Product Manual

Operations

6.1.4 Response to diagnostic command

When the master device receives an EXECUTE DEVICE DIAGNOSTIC
command and the slave device is present, the master device checks the PDIAG-
signal for up to 6 seconds to see if the slave device has completed the self-
diagnosis successfully.
The master device does not check the DASP- signal.
After the slave device receives the EXECUTE DEVICE DIAGNOSTIC
command, it shall report the result of the self-diagnostics to the master device as
described below:
PDIAG- signal: negated within 1 ms and asserted within 5 seconds
When the IDD is set to a slave device, the IDD asserts the DASP- signal when
negating the PDIAG- signal, and negates the DASP- signal when asserting the
PDIAG- signal.
X'1F7' Reg.
Write
Master device
Status Reg.
BSY bit
Slave device
BSY bit
PDIAG-
DASP-
Figure 6.4 Response to diagnostic command
6-6
Max. 6 sec.
If the slave device is preset, PDIAG- signal is checked for
up to6 seconds.
Max. 1 ms.
Max. 5 sec.
C141-E120-02EN