Western Digital WDG2TP10000N - My Book Pro Edition II Hard Drive Array User Manual page 17

Condition Messages
My Book RAID Manager reports the following condition messages depending on the
current status of your drive.
Message
Healthy
Degraded
Rebuilding
Bad
Setting Mismatched
Not Configured
Unknown
Description
Your device is "healthy" and operating.
Your device is still functioning but the drive in either slot A
or B may have a problem. Refer to section 7 of this manual
for information on how to replace a drive.
Your device is in RAID 1 mode and is rebuilding the data
for a newly replaced disk. The rebuilding process may take
up to 12 hours depending on the capacity of your drive.
Your data in the device is still accessible while it's
rebuilding.
Your device may have a problem. Disconnect then re-
connect the power cable and/or the interface cable. If the
problem persists, visit our WD knowledge base at
support.wdc.com for more information and help.
Your device is in RAID 1 mode with both drives detected as
master. You must designate a single master (disk A or B)
using RAID Manager. The data on the master will be
accessed and mirrored to the secondary drive during the
rebuilding process.
The RAID setting is not configured. Use RAID Manager to
configure it to either RAID 0 or RAID 1.
The RAID configuration information is not available. The
driver for My Book interface device may not be installed
properly. Turn off the device, re-install My Book RAID
Manager and/or drivers from the software CD and turn the
device back on. Your system should detect My Book and
prompt you to install the driver. Allow your system to
automatically locate the driver and complete the installation.
MY BOOK PRO EDITION II
MY BOOK RAID MANAGER FOR WINDOWS – 14
USER MANUAL