Control Station - Chamberlain GH Installation Manual

CONTROL STATION

ON
To prevent possible SERIOUS INJURY or DEATH from
electrocution:
• Be sure power is NOT connected BEFORE installing door
control.
To prevent possible SERIOUS INJURY or DEATH from a closing
door:
• Install door control within sight of door, out of reach of
children at a minimum height of 5 feet (1.5 m) and away from
ALL moving parts of door.
• Install the control station far enough from the door to prevent
the user from coming in contact with the door while operating
the controls.
SEMENT
NOTE: The low voltage control circuit wiring requires insulated,
20 AWG or greater wire. Refer to back page for additional control
ION
wiring.
1
Remove the control station cover.
Fasten the control station to the wall at least 5 feet above the
2
ground. The installation surface must be smooth and fl at.
Attach the MAS label to the side of the control station.
3
ENCIA
CIÓN
1
^
O P
E N
^
O
S T
O P
2
5'
UL Entrapment Placard
WARNING
5
Moving Door Can Cause
Serious Injury or Death
Keep Clear! Door May Move at any Time
Without Prior Warning
Do Not Let Children Operate the Door or Play
in the Door Area
Keep Door in Sight at all Times When Door is Moving
Maintenance
Alert System
If light is Flashing
Rapidly, it is time
for routine door
maintenance.
If light is Flashing
Slowly, followed
by a pause, call for
immediate service.
Service every
cycles/months
WARNING
WARNING WARNING
• Install the entrapment warning placard on wall next to the
control station in a prominent location that is visible from the
door.
• NEVER permit children to operate or play with door control
push buttons or remote controls.
• Activate door ONLY when it can be seen clearly, is properly
adjusted and there are no obstructions to door travel.
• ALWAYS keep door in sight until completely closed. NEVER
permit anyone to cross path of closing door.
AVERTISSEMENT
3
Select appropriate knockout and run the wires to the
operator.
AVERTISSEMENT
4
Connect wires to the control station and replace the control
station cover.
5
Fasten the entrapment warning placard next to the control
station.
4
24VAC
24VAC
DATA
TIMER
DEFEAT
COMMON
24VAC
POWER
24VAC
TIMER
DEFEAT
COMMON
MAS LMEP
LMEP:
TIMER
EDGE
EDGE:
NABLE
OPEN
OPEN
CLOSE
ADVERTENCIA
STOP
CLOSE
COMMON
N
STOP
SBC
ADVERTENCIA
COMMON
MAS Label
TM
19
14
13
12
11
MAS
10
9
8
7
6
5
4
3
2
SBC
1
OPEN
3-Button
Station
CLOSE
STOP
Maintenance
Alert LED
(RD) (WH)
Open
Close
Stop
Wiring - Control station