Page 1
BY A TRAINED DOOR SYSTEMS TECHNICIAN Installation Date ONLY. Operators are shipped in C2 operating mode. Visit www.liftmaster.com to locate a professional installing dealer in your area. CONTACT INFORMATION THIS OPERATOR FEATURES THE ENHANCED The Maintenance Alert System™ allows the installer to set an internal Maintenance Cycle Counter.
INTRODUCTION Congratulations on purchasing a quality, LiftMaster Logic 4 Commercial Door Operator. Your new operator is capable of operating up to 12 cycles per hour or 50 cycles per day. It is equipped with a built in radio receiver that is compatible with our existing 315 MHz product ®...
LIFTMASTER MONITORED ENTRAPMENT PROTECTION (LMEP) LIFTMASTER MONITORED ENTRAPMENT PROTECTION (LMEP) DEVICE IS REQUIRED DEVICE IS RECOMMENDED A LiftMaster Entrapment Protection (LMEP) device is required for A LiftMaster Entrapment Protection (LMEP) device is the following wiring types. recommended for the following wiring types.
® Built in 3-channel, 315 MHz radio receiver allows you to add as many as 23 Security✚ remotes or dip switch remote controls. NOTE: The following programming requires a LiftMaster Monitored Entrapment Protection (LMEP) device. SINGLE BUTTON REMOTE CONTROL AVERTISSEMENT...
To prevent possible SEVERE INJURY or DEATH: CAUTION • Activate door ONLY when it can be seen clearly, is properly • Install a LiftMaster Monitored Entrapment Protection (LMEP) adjusted and there are no obstructions to door travel. device. • ALWAYS keep door in sight until completely closed. NEVER •...
MANUAL RELEASE WARNING WARNING To prevent possible SERIOUS INJURY or DEATH from a falling door or arm: CAUTION • DO NOT stand under the door arm when pulling the emergency • NEVER use emergency release handle unless doorway is clear release.
MANUAL RELEASE EMERGENCY DISCONNECT SYSTEM CAUTION CAUTION MODEL H, GH, J, AND HJ To prevent possible SERIOUS INJURY from a moving chain: • DISCONNECT electric power to the operator BEFORE manually This operator has provisions for manually operating the door operating your door.
Page 8
WARNING WARNING TESTING Apply power to the operator. CAUTION WARNING WARNING When power is applied to the operator, the following LED’s will illuminate: STOP, CLOSE, OPEN, LMEP, 24Vac, RADIO, DATA, To avoid SERIOUS personal INJURY or DEATH: TIMER ENABLE, OLS MID, SLS, CLS, and MAS. Once the power •...
Every 3 months or 5,000 cycles repeat all tests in the Testing section. Call a trained door systems technician. To locate a dealer in your area visit us online at www.liftmaster.com. The operator should be serviced at the following intervals: •...
May be welded. For use with J, H, DJ, and horns/strobes at various door positions, and to provide DH operators. special timer functions. Cast iron bracket to mount J, H, DH, DJ, and GH side mount 08-9098 operators on end bracket of a rolling door or grill. For AUXCARD Auxiliary Contact Card: vertical or horizontal mount on either front or top of coil.