Wall Installation - AT&T CL82309 - DECT 6.0 User Manual

Getting started

Wall installation

Your telephone base is ready for tabletop use. If you want to mount your
telephone on a wall, use the provided wall mount bracket to connect with a
standard dual-stud telephone wall mounting plate. If you do not have this
mounting plate, you can purchase one from many hardware or consumer
electronic retailers. You might need a professional to install the mounting
plate.
Tabletop to wall installation
1. Position the telephone base as shown below. Insert the extended tabs
(marked A) of the wall mount bracket into the slots on the back of the
telephone base (marked A). Push the telephone base down until it is
securely in place.
2. If you are using a DSL filter, plug the line cord into the filter now. Route
the telephone line cord (or DSL filter) through the wall mount bracket hole.
Route the power cord out of the bottom of the telephone.
3. Plug the telephone line cord (or DSL filter) into the wall jack. Plug the
power adapter into a power outlet not controlled by a wall switch.
4. Align the holes on the wall mount bracket with the standard wall plate and
slide the wall mount bracket down until it locks securely. Bundle the
telephone line cord and power adapter cord neatly with a twist tie.
1.
3.
2.
4.
8