Table of Contents
Advertisement
Altos R5250 Installation Configuration Guide
RAID
Onboard NVIDIA
NFP3600 Chipset
Onboard NVIDIA
nForce Networking
Controller
Onboard XGI Z9s
ATI FireGL V5200
Software Required
The management utility for onboard SATA RAID can be found in the EasyBUILD
8.0 build 100 (or later).
Software
Onboard SATA
RAID utility
Configuring onboard SATA RAID
Please refer to the Appendix A. for the Onboard SATA RAID Configuration.
Installation Tips
Since Red Hat Enterprise Linux 5 cannot recognize the onboard SATA
1.
RAID, you need to make a driver diskette from the EasyBUILD 8.0 build
100 (or later) first before the installation.
Type linux dd when the prompt boot: appears at the start.
2.
Please select the sda as the Driver Disk Source.
3.
Follow the instruction to load the onboard SATA RAID driver from the
4.
driver diskette.
At the Package Installation Defaults, select Customize software packages
5.
to be installed.
At the Package Group Selection step, select Graphic Internet under
6.
Applications.
If you have installed the ATI FireGL V5200 in the system, please also select
7.
Development Tools and under Development. If you don't have ATI FireGL
V5200, please go to next step directly
After adding the additional packages, follow the normal procedure to
8.
finish the installation.
Gigabit Ethernet Driver Installation
The Gigabit Ethernet driver installation is the same as SAS daughter board
installed. Please refer to the Red Hat Enterprise Linux 5.0 Installation (SAS
Daughter Board) Gigabit Ethernet Driver Installation section.
90
\
N/A
OS built-in
0.62
\Disk\R5250\NIC\Nvidia\rhel5\
1.12.03
\Disk\R5250\onboard\xgiz9s\rhel5\
8.35.5
\Disk\R5250\graphic\V5200\rhel5\
Version
Directory on EasyBUILD
9.44
\app\R5250\onboard\sataraid\Linux\rhel
5\
Advertisement
Table of Contents
