Media Page; Media Defaults - Xerox 850DP - Phaser Color Solid Ink Printer User Manual

1. Four margins may be set independently: Left, Top, Bottom and Right. Enter the
desired margins (0 to 2540 mm, or 0.0 to 100.0 inches) in the corresponding text
boxes.
2. Press the Update Printer button to update the default margins in the printer.

Media Page

Navigation: PRINTER DEFAULTS > PROCESSING DEFAULTS > Media

Media Defaults

If you entered the printer password in the Session Setup, you can change the following
default media parameters in the printer:
1. Media Size - Click on this list box to select the printer default paper size. Jobs
received by the printer without a specified paper size are printed on this media size. If
Auto scaling is enabled on the Transform page, the following paper sizes are not
allowed: ANY, ANY ANSI, ANY ISO, ANY JIS, and ANY ARCH.
2. Media Type - Click on this list box to select the printer default media type. Jobs
received by the printer without a specified media type are printed on this media type.
3. Media Source - Click on this list box to select the source of the media from the
available sources of media in the printer. The AUTO selection will allow the printer to
automatically select the correct media source. The choices are: ROLL 1, ROLL 2,
ROLL 3, ROLL 4, MANUAL FEED, and AUTO. (The roll choices are dependent on the
type of printer).
4. Media Size Detect - Click on this list box to set the method the printer will use to
detect the size of the media required to hold the printed image. The choices are PLOT
SPECIFIED or DRAWN AREA.
PLOT SPECIFIED - If the job data contains an embedded command explicitly
requesting a particular page size (e.g., the PS command in HPGL/2), the job data will
be used to determine the size of the page on which the image will be drawn.
DRAWN AREA - The AccXES Controller will determine the page size required,
based upon the bounding box of the drawn image.
5. Collation - Click on the Collation list box to select Off or On.
6. Copies - Enter the printer's default number of copies (1 to 999) in this text box.
7. Oversize Margin - When Media Size is set to ANY, ANY ANSI, ANY ARCH, or ANY
ISO, this parameter determines the percentage of image oversizing that will be
allowed before selecti ng a larger, installed media size, of the same type, to fit the
printed image on. The range is 0 to 100%, with a factory default setting of 1%.
8. Undersize Margin - When Media Size is set to ANY, ANY ANSI, ANY ARCH, or ANY
ISO, this parameter determines the percentage of image undersizing that will be
allowed before selecting a smaller, installed media size, of the same type, to fit the
printed image on. The range is 0 to 100%, with a factory default setting of 2%.
9. Maximum Plot length - In this text box, enter the maximum length that the printer will
plot. On the WIDE FORMAT PRINT SYSTEM 8830/8825/8850/ 510DP, the range is
from 121.92 cm to 2438.40 cm, or from 48 inches to 960 inches. The maximum length
Page 46
Web Print Manager Tool User Guide