Biostar M7VIG PRO Bios Setup Manual page 24

M7VIG Pro BIOS Setup
DPMS
Initial display power management signaling.
Modem Use IRQ
This determines the IRQ, which can be applied in MODEM use.
The Choices: 3 (default),4 / 5 / 7 / 9 / 10 / 11 / NA.
Soft-Off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the system to enter the
Soft-Off state when the system has "hung."
The Choices: Delay 4 Sec, Instant-Off (default).
State After power failure
This field determines the action the system will automatically take when power is restored
to a system that had lost power previously without any subsequent manual intervention.
There are 3 sources that provide current to the CMOS area that retains these Power-On
instructions; the motherboard battery (3V), the Power Supply (5VSB), and the Power
Supply (3.3V). While AC is not supplying power, the motherboard uses the motherboard
battery (3V). If AC power is supplied and the Power Supply is not turned on, 5VSB from
the Power Supply is used. When the Power Supply is eventually turned on 3.3V from the
Power Supply will be used.
There are 3 options: "Former-Sts", "On", "Off".
"Former-Sts"
"On"
"Off" (default)
For example: If set to "Former-Sts" and AC power is lost when system is live, then after
AC power is restored, the system will automatically power on. If AC power is lost when
system is not live, system will remain powered off.
Wake Up/ Power On Control
If you highlight the literal "Press Enter" next to the "Wake Up/ Power On Control" label
and then press enter key, it will take you to a submenu with the following options:
Power On by PCI card
When you select Enabled, a PME signal from PCI card returns the system to
Full On state.
The Choices: Disabled (default), Enabled.
Means to maintain the last status of the CMOS when AC
power is lost.
Means always set CMOS to the "On" status when AC
power is lost
Means always set CMOS to the "Off" status when AC
power is lost.
23