Drive assembly components
Main motor assembly
Note
Switch off the power and disconnect the power cord.
1.
Remove the electrical card cage as detailed in "Electrical card cage" on
page 98.
2.
Remove the printer unit chassis as detailed on page 100.
3.
Disconnect each wiring harnesses from the four imaging drum motors.
4.
Remove the five screws securing the main motor assembly to the frame.
5.
Lift the front of the main motor assembly about 2 cm (3/4 in.)
6.
Carefully guide the ribbon cable through the assembly as you lift the
main motor assembly and remove.
Service Guide
141