Paper transport components
Tray 1 entrance sensor actuator
Warning
Switch off the power and disconnect the power cord.
1.
Remove the printer unit chassis as detailed in the topic on page 100.
2.
Turn the printer unit chassis upside-down and then carefully squeeze
the actuator's two locking tabs and remove the sensor.
Entrance Sensor Activator
Ensure spring
end is set on
post
Removing the tray 1 entrance sensor actuator
For reassembly, reinstall the entrance sensor actuator. Ensure the spring arm is on
the plastic post. Reverse these steps to install the tray 1 entrance sensor actuator.
0725-33
Printer Unit Chasis
Service Guide
121