Buick ENCLAVE - 2009 Owner's Manual page 218

3-100 Instrument Panel
To Transfer Audio to the Cell
Phone
During a call with the audio in the
vehicle:
b g
1. Press . The system
responds with "Ready" followed
by a tone.
2. Say "Transfer Call." The system
responds with "Transferring call"
and the audio will switch from
the vehicle to the cell phone.
To Transfer Audio to the
In-Vehicle Bluetooth System
The cellular phone must be paired
and connected with the Bluetooth
system before a call can be
transferred. The connection process
can take up to two minutes after
the key is turned to the ON/RUN or
ACC/ACCESSORY position.
During a call with the audio on the
b g
cell phone, press
than two seconds. The audio
switches from the cell phone to the
vehicle.
Voice Pass-Thru
Voice Pass-Thru allows access to
the voice recognition commands on
the cell phone. See the cell
phone manufacturers user guide to
see if the cell phone supports
this feature. This feature can be
used to verbally access contacts
stored in the cell phone.
1. Press and hold
two seconds. The system
responds with "Ready" followed
by a tone.
2. Say "Bluetooth". The system
responds with "Bluetooth
ready" followed by a tone.
3. Say "Voice". The system
responds with "OK, accessing
<phone name>".
•
The cell phone's normal
prompt messages will
go through its cycle according
for more
to the phone's operating
instructions.
Dual Tone Multi-Frequency
(DTMF) Tones
The in-vehicle Bluetooth system can
send numbers and numbers
stored as name tags during a call.
This is used when calling a
menu driven phone system. Account
numbers can be programmed into
the phonebook for retrieval
during menu driven calls.
b g
for
Sending a Number During a Call
1. Press
2. Say "Dial". The system responds
3. Say the number to send.
b g
. The system
responds with "Ready" followed
by a tone.
with "Say a number to send
tones" followed by a tone.
•
If the system clearly
recognizes the number it
responds with "OK, Sending
Number" and the dial
tones are sent and the call
continues.