Buick ENCLAVE - 2009 Owner's Manual page 190

3-72 Instrument Panel
Adjusting the Speakers
(Balance/Fade)
BAL/FADE (Balance/Fade): To
adjust the balance or fade:
f
1. Press until the speaker control
labels display.
f
2. Continue pressing
the desired label, or press the
pushbutton under the desired
label.
3. To adjust the highlighted setting,
do one of the following until the
desired levels are obtained.
f
•
Turn clockwise or
counterclockwise.
•
Press \ FWD, or
To quickly adjust balance or fade to
the middle position, press the
pushbutton positioned under the
BAL or FADE label for more
than two seconds. A beep sounds
and the level adjusts to the
middle position.
To quickly adjust all speaker and
tone controls to the middle position,
f
press
until a beep sounds.
Radios with CD and DVD fade
differently depending on the DVD
Media type:
to highlight
•
With DVD-A 5.1 Surround media,
the left front and right front
speakers fade rearward, leaving
the center front speakers
unaffected until the last fade step,
then all front speakers mute.
•
With DVD-V 5.1 Surround media,
surround sound is maintained
until Step 4 of the Fade control is
reached while fading rearward. At
s REV. that point the audio system output
changes to Stereo to prevent the
loss of Center channel output
when the full rearward fade
position is reached.
If the Rear Seat Audio (RSA) is
turned on, the radio disables FADE
and mutes the rear speakers.
for more than two seconds
Finding a Category (CAT)
Station
CAT (Category): The CAT button
is used to find XM stations when
the radio is in the XM mode. To find
XM channels within a desired
category:
1. Press BAND until the XM
frequency displays.
2. Press CAT to display the
category labels.
3. Continue pressing CAT until the
desired category name displays.
•
Radios with CD and DVD
can also navigate the
category list by pressing
REV or \ FWD.
4. Press either of the two buttons
below the desired category
label to immediately tune to the
first XM station associated
with that category.
s