Buick ENCLAVE - 2009 Owner's Manual page 212

3-94 Instrument Panel
instructions on the cell phone to
enter the four digit PIN number
that was provided in Step 3.
5. The system prompts for a name
for the phone. Use a name that
best describes the phone.
This name will be used to
indicate which phone is
connected. The system then
confirms the name provided.
6. The system responds with
"<Phone name> has been
successfully paired" after the
pairing process is complete.
7. Repeat Steps 1 through 7 for
additional phones to be paired.
Listing All Paired and Connected
Phones
b g
1. Press and hold
seconds. The system responds
with "Ready" followed by a tone.
2. Say "Bluetooth". The system
responds with "Bluetooth
ready" followed by a tone.
3. Say "List". The system lists all
the paired Bluetooth devices.
If a phone is connected to
the vehicle, the system will say
"Is connected" after the
connected phone.
Deleting a Paired Phone
1. Press and hold
two seconds. The system
responds with "Ready" followed
by a tone.
2. Say "Bluetooth". The system
responds with "Bluetooth
ready" followed by a tone.
3. Say "Delete". The system asks
which phone to delete followed
by a tone.
4. Say the name of the phone to be
for two
deleted. If the phone name is
unknown, use the "List"
command for a list of all paired
phones. The system responds
with "Would you like to delete
<phone name>? Yes or No"
followed by a tone
5. Say "Yes" to delete the phone.
Linking to a Different Phone
1. Press and hold
b g
for
2. Say "Bluetooth". The system
3. Say "Change phone". The
The system responds with "OK,
deleting <phone name>".
b g
for
two seconds. The system
responds with "Ready" followed
by a tone.
responds with "Bluetooth
ready" followed by a tone.
system responds with "Please
wait while I search for other
phones".
•
If another phone is found, the
response will be "<Phone
name> is now connected".
•
If another phone is not found,
the original phone remains
connected.