Buick ENCLAVE - 2009 Owner's Manual page 111

4. The indicator light on the
Universal Home Remote
will flash slowly at first and then
rapidly after Universal Home
Remote successfully receives the
frequency signal from the
hand-held transmitter. Release
both buttons.
5. Press and hold the newly-trained
Universal Home Remote button
and observe the indicator light.
If the indicator light stays on
continuously, the programming is
complete and the garage door
should move when the Universal
Home Remote button is pressed
and released. There is no need
to continue programming Steps 6
through 8.
If the Universal Home Remote
indicator light blinks rapidly
for two seconds and then turns
to a constant light, continue
with the programming Steps 6
through 8.
It may be helpful to have another
person assist with the remaining
steps.
6. After Steps 1 through 5 have
been completed, locate inside
the garage the garage door
opener receiver (motor-head
unit). Locate the "Learn" or
"Smart" button. The name and
color of the button may vary
by manufacturer.
7. Firmly press and release the
"Learn" or "Smart" button.
After you press this button,
you will have 30 seconds
to complete Step 8.
Features and Controls
8. Immediately return to the vehicle.
Firmly press and hold the
Universal Home Remote button,
chosen in Step 3 to control
the garage door, for two seconds,
and then release it. If the
garage door does not move,
press and hold the same button
a second time for two seconds,
and then release it. Again, if
the door does not move, press
and hold the same button a
third time for two seconds, and
then release.
The Universal Home Remote
should now activate the
garage door.
To program the remaining
two Universal Home Remote
buttons, begin with Step 2 of
"Programming the Universal Home
Remote System." Do not repeat
Step 1, as this will erase all previous
programming from the Universal
Home Remote buttons.
2-47