Intel 2ND GENERATION CORE PROCESSOR FAMILY DESKTOP - DATASHEET VOLUME 2 01-2011 Datasheet page 161

Processor Configuration Registers
B/D/F/Type:
Address Offset:
Reset Value:
Access:
Size:
BIOS Optimal Default
Bit
2
1
0
Datasheet, Volume 2
0/6/0/PCI
3E–3Fh
0000h
RO, RW
16 bits
0h
Reset RST/
Attr
Value PWR
RW 0b Uncore
RW 0b Uncore
RW 0b Uncore
Description
ISA Enable (ISAEN)
Needed to exclude legacy resource decode to route ISA resources
to legacy decode path. Modifies the response by the root port to an
I/O access issued by the processor that target ISA I/O addresses.
This applies only to I/O addresses that are enabled by the IOBASE
and IOLIMIT registers.
0 = All addresses defined by the IOBASE and IOLIMIT for
processor I/O transactions will be mapped to PCI Express-G.
1 = The root port will not forward to PCI Express-G any I/O
transactions addressing the last 768 bytes in each 1KB block
even if the addresses are within the range defined by the
IOBASE and IOLIMIT registers.
SERR Enable (SERREN)
0 = No forwarding of error messages from secondary side to
primary side that could result in an SERR.
1 = ERR_COR, ERR_NONFATAL, and ERR_FATAL messages result
in SERR message when individually enabled by the Root
Control register.
Parity Error Response Enable (PEREN)
This bit controls whether or not the Master Data Parity Error bit in
the Secondary Status register is set when the root port receives
across the link (upstream) a Read Data Completion Poisoned TLP.
0 = Master Data Parity Error bit in Secondary Status register can
NOT be set.
1 = Master Data Parity Error bit in Secondary Status register CAN
be set.
161