Ulead VIDEOSTUDIO 11 User Manual page 103

the audio moves from one speaker to another and creating a "surround sound"
effect.
Adjusting stereo channels
Stereo files (two channels) have two waveforms representing the left and right
channels accordingly.
To use stereo mode:
1. Click Enable/Disable 5.1 Surround in the Toolbar. Select Music Track in the
Options Panel.
Tip: To check if the 5.1 Surround is disabled, click Audio View in the Toolbar.
2. Click Play in the Options Panel.
3. Click the music note symbol in the center of the Surround Sound Mixer. Drag it
to either right or left, depending on your preferred sound position.
Note: Moving the note symbol will amplify the sound coming from your preferred
direction.
4. Drag Volume to adjust the volume level of the audio.
Mixing Surround Sound
All audio channels in Surround Sound have a set of similar controls that you will
find in the stereo configuration of this panel, plus a few more specific controls.
• Six-channel VU Meter Front Left, Front Right, Center, Sub-woofer,
Surround Left, Surround Right.
• Center controls the amount of output sound from the center speaker.
• Sub-woofer controls the amount of low-frequency sound output.
ULEAD VIDEOSTUDIO USER GUIDE
103