Capturing Tv Footage; Dv Quick Scan; Importing From Dvd/Dvd-Vr - Ulead VIDEOSTUDIO 10 User Manual

52
ULEAD VIDEOSTUDIO USER GUIDE
After fine tuning the volume, you can start capturing footage from your analog
device. Use the controls on your analog device to scan your videotape and locate
the footage that you want to capture.
Tip: A delay in capture may be due to the confirmation dialog box or connection
between devices. It is better to rewind your tape to an earlier point before the actual
footage you want to capture and just trim the video later.

Capturing TV footage

VideoStudio allows you to capture TV footage through a TV tuner. Capture a
segment of your favorite television show on regular TV or cable then save it in your
hard drive in AVI, MPEG, or Windows Media Format.
Before capturing, you need to choose the following settings in the Options Panel:
1. Select your TV tuner device from the Source drop-down list.
2. In the TV channel box, specify the channel number from which to capture.
3. Click Options: Video and Audio Capture Property Settings to open the
Video and Audio Capture Property Settings dialog box. Check if the Video
Input source, TV system, and Audio Input source are set correctly. If not,
adjust the settings accordingly.
Click the Channel tab to choose Antenna or Cable TV, scan available channels in
your region, and more.

DV Quick Scan

Use this option to scan a DV device for scenes to import. To use DV Quick Scan,
refer to the first step in the DV-to-DVD Wizard section.

Importing from DVD/DVD-VR

You can import DVD/DVD-VR formatted video from a disc or from your hard drive
into VideoStudio.
To import from DVD/DVD-VR:
1. Click the Capture Step then click Import from DVD/DVD-VR.
2. Select your DVD drive and then click Import DVD Folder.