Compaq 1200US - Presario - Celeron 800 MHz Maintenance And Service Manual page 65

Models: 1246, 1247, 1277, 1278, and 1279
| Home Page
Illustrated Parts Catalog
Removal and Replacement Procedures
Maintenance & Service Guide
Presario Series
| Notice | Preface
| Removal & Replacement Procedures
Pin Assignments
| Product Description
| Battery Pack Operations
| Troubleshooting
| Specifications
Removing the Display
Panel Assembly,
continued
9. Remove the LVDS
connector on the end of
the display flex data cable
This step applies only
if using an LVDS
NOTE: connector. If using a
CMOS connector,
disregard this step.
Compaq
recommends
replacing the
LVDS
interface
IMPORTANT:
connector on
the display
flex data
cable after
removing.
CAUTION: The
connector on the end
of the flex cable must
be removed before
the cable can be
routed through the
slot on the Upper CPU
cover.
10. Gently pull the flex data
cable and backlight cable
attached to the display panel
assembly through the slot on
the Upper CPU cover and
remove the display panel
assembly with flex data and
backlight cable attached.
When removing the
display panel
assembly, observe
NOTE:
the display panel
assembly flex cable
routing and position.
To replace the display panel
assembly, reverse the
previous procedures.
Return to Removal &
Replacement Procedures
.