Removing The Processor Air Dam; Figure 15. Installing The Processor Air Dam - Intel SR2400SYS - Server Platform - 0 MB RAM User Manual

Removing the Processor Air Dam

If you install only a single processor, the processor air dam must be installed on the underside of
the processor air duct. If you install two processors, the air dam must be removed from the air duct.
For instructions on adding or replacing a processor, first remove the processor air duct and the
processor air dam, and then see your server board user guide for instructions on processor
installations and removals. Return to these instructions to reinstall the processor air dam and the
processor air duct.
1. Observe the safety and ESD precautions at the beginning of this book. See
Information."
2. Power down the server and unplug all peripheral devices and the AC power cable or DC
external source.
3. Remove the chassis cover. For instructions, see
4. Remove the processor air duct. For instructions, see
5. Turn the processor air duct over to reveal the underside of it.
6. Remove the air dam by sliding the slotted holes from the duct pins. See the figure below. Save
the air dam for future use.
7. Install the processor air duct. For instructions, see
8. Install the chassis cover. For instructions, see
9. Plug in all peripheral devices and connect the AC power cable or DC external source to the
server.
20

Figure 15. Installing the Processor Air Dam

"Installing the Chassis
"Removing the Chassis Cover."
"Removing the Processor Air
TP01117
"Installing the Processor Air
Cover."
"Safety
Duct."
Duct."